Specifications

Bank 2
These switches can manually override any ZPL commands that affect print
mode, media mode, and media type. They can also override settings established
during the calibration procedure.
If you do not want to override ZPL or the calibration settings, disable one or
more of the options by setting switches 1, 4, and/or 7 to the “R” position and
turn the power on. With these disabled, the printer will require ZPL commands
to set print mode, media mode, and/or media type.
To override, set the switches to one of the modes shown in the table. If you are
in the process of printing, this change takes affect on the next label printed. If
you change the switches from active to disabled after printer power-up, the
printer remains in the current mode until a ZPL command changes the mode.
Bank 2
Switch
321
Print Mode
R R L Cutter
R L L Tear Off
L R L Peel Off
L L L Rewind
- - R Disabled
Switch
6 5 4 Media Mode
R R L Non-continuous mark sense
R L L Non-continuous web sense
L L L Continuous
- - R Disabled
Switch
8 7 Media Type
R L Thermal transfer
L L Direct thermal
- - R Disabled
Getting Ready to Print S -Series Maintenance Manual: Volume 1
Page 2-14 38452L Rev. 3