Specifications

Lower Media Sensor Adjustment
1. Locate the lower media sensor assembly under the rear idler roller
(Figure 2.10-A). (It is a spring clip holding a circuit board.)
2. Slide the sensor until the two brass-colored infrared emitters are under the
upper media sensor. Gently pull wires out as needed (wires should have a
little slack).
3. NOTE: If the sensor is being moved inward and a large loop of wire
develops, remove the cover from the electronics side of the printer and
gently pull the wires through. Clamp the wires so that they do not rub any
belts.
A
Figure 2.10 Lower Media Sensor
S -Series Maintenance Manual: Volume 1 Getting Ready to Print
38452L Rev. 3 Page 2-11