Specifications

To adjust for the outside half of the media (160S ONLY):
1. Remove the ribbon. Locate the upper media sensor (Figure 2.9-A).
2. Remove the printer’s left side panel and reroute the media sensor cable to
provide additional slack.
3. Remove the Phillips head screw to release the upper section of the sensor
and wire cover.
4. Lift the upper media sensor assembly and move the sensor and the wire
cover to the outside half. Carefully pull the wires through the tie wrap.
You may need to set aside the sensor wire cover if the adjustment is far to
the outside.
5. Replace and tighten the Phillips head screw.
6. Make sure the wires are routed back into the groove of the media sensor
bracket.
7. Replace the printer’s left side panel.
A
Figure 2.9 Upper Media Sensor
Getting Ready to Print S -Series Maintenance Manual: Volume 1
Page 2-10 38452L Rev. 3