Specifications

Adjusting the Tear-Off Position
This procedure sets the rest position of the media over the Tear Bar after
printing. The possible adjustment range is approximately plus or minus 80 dot
rows. Power need not be turned off to reset this parameter.
NOTE: The printer configuration label reports the actual number of dot rows,
not the number of presses of the buttons used for adjustment.
1. Press the MODE key twice. The PAUSE and POSITION lights turn on.
2. Press the UP or DOWN key to adjust the current setting.
3. Press the MODE key twice. The MODE lights will flast on and off to
indicate that the settings have been saved in memory.
4. Press PAUSE to exit the PAUSE mode; the PAUSE light turns off.
This illustration shows how higher values move the label further out from
the printer (moves the tear line closer to the leading edge of the next label)
while lower values move the label into the printer (moves the tear line
closer to the edge of the printed label).
Figure 2.8 Tear-Off Position Adjustment
Getting Ready to Print S -Series Maintenance Manual: Volume 1
Page 2-8 38452L Rev. 3