User`s manual

Media Rewinding The rewinder allows the print and rewind of
partial label rolls.
Rewinder Capacity
The quantity of media re-rolled will vary due to
environmental conditions and media
properties.
Step 1 Open the media access door. Load media.
Load and set media parameters (via AutoSense
or programming with the Q command) in the
printer.
Step 2 Remove the lower front cover. Lift up on the
lower front cover while holding down the
printer’s base. The cover will un-snap with
steady upward pressure and slide up and then
out the front.
Installation & Operation
24 980412-001 Rev.A
Lift (1)
Pull Out (2)
Reverse the process to re-install
the lower front cover