User`s manual

Label Dispense
Mode
The printer can dispense a single peeled label
and rewind the backing in the Dispense (Peel)
mode. Removing the presented label will
prompt the printer to print the next label.
Step 1 Open the media access door. Load media (la
-
bels). Load and set label parameters (via
AutoSense or programmed with the Q com
-
mand) in the printer.
Step 2 Press the FEED button until approximately 16
inches (40 cm) of media has exited the printer.
Step 3 Remove the exposed labels from the media
liner (backing).
980412-001 Rev.A 19
Installation & Operation
Power ON
Labels Loaded
Press FEED
Peel Exposed Labels