User`s manual

Media Loading
Step 11
Press the Feed button once (with the power ap
-
plied and the power switch “ON”).
Step 12 Set label detection parameters for media:
• Use the AutoSense procedure (page 18) for
first time use of new media to set transmissive
(gap) sensor.
• Use the AutoSense procedure for detection
of label and gap lengths.
• Use programming to set continuous media
mode. See the Q command in the EPL2 pro-
grammer's manual for details.
Configure the print mode with the O (thermal
transfer) and OD (direct thermal) commands.
See the EPL2 programmer's manual for
important
details on the Option (O) command.
The print mode will be set until changed by
programming.
DO NOT turn the power switch OFF (0) while
reloading media or data loss may result. The
printer will automatically resume printing when
a new label roll has been loaded.
Installation & Operation
16 980412-001 Rev.A
FEED
Power ON
Labels Loaded
Press FEED