Service manual

Packaging for Shipment
To ship or store the printer, make sure all components are packed as shown in the figure below.
980428-160 Rev. 1 Prelim. 75
Printer Preparation
1. Close the printhead.
2. Place and lock the rewind bracket in the
rear of the printer base.
3. Close the label dispenser (peeler).
4. Mount the lower front cover.
5 Tape (masking tape) the rewind clip to the
rewind tube.
Packaging the Printer
Move the printer carefully. While the printer has
sturdy construction, mechanical damage can
certainly result from falls or rough handling.
1. Place the printer into the large plastic
shipping bag to prevent the dust and
vibration damage from the foam rubbing on
the outside surfaces.
2. Put the two (2 ) foam end caps on the
printer.
UP
KEEP DRY
FRAGILE
UP
KEEP DRY
FRAGILE
UP
KEEP DRY
FRAGILE
UP
KEEP DRY
FRAGILE
3. Seal the bottom of the shipping carton with
reinforced shipping tape.
4. Place the printer with the foam end caps
into the shipping carton with the printer’s
feet down.