Service manual

Resetting the printhead
1. After replacing the printhead, select the Reset Head Odometer in the Printer menu.
Only do this procedure once per printhead! The printer records each printhead
odometer reading in ten (10) memory storage locations. Resetting the printhead odometer
increments the printhead odometer memory location pointer and clears that printhead record.
After all ten (10) printhead odometer storage locations have been filled, the printer will return
to the first location to begin re-use of the printhead odometer record locations. See the Head
History report to check printhead odometer readings and usage.
2. Important - Clean the printhead if it was not cleaned immediately after installation. Oils
and acids from handling will damage the printhead if not removed immediately.
Note - The printer’s odometer can not be set or reset. New PCBA’s odometers are set to zero by
default.
980428-157 Rev. 1 Prelim. 74