Service manual

Tension Adjustment
1. Hold the appropriate tube's pulley or collar and rotate the outside of the tube until the slot on
the end of the tube aligns with the inside set screw of the tube assembly.
2. Loosen the set screw.
3. Push the tube's clutch spring into the tube with the torque tools tip. The tool's prongs touch the
clutch spring's stop collar. Pushing the clutch stop collar in increases torque and out decreases
torque. Tighten the stop collars set screw to 11 inch-pounds torque.
4. Measure tube tension.
5. Repeat until adjusted properly.
Do not disassemble the tube!
Do not replace parts in the tube assembly.
70 980428-154 Rev. 1 Prelim.