Service manual

980428-147 Rev. 1 Prelim. 65
Note - See the user's manual or cutter
mounting instruction to mount and use the
cutter.
Cutter Cable
Exits Here
Installation
1. Connect the cutter cable (JP15) to the main
PCBA.
2. Insert the cutter through the center panel
next to the motor cable.
3. Tie the cutter cable to the motor cable about
1.5 inches from the motor cable's connector
on the main PCBA.
4. Attach the cutter cable to the main cable
bundle at the front cable anchor tie on the
power supply.
5. Add the spiral wrap to the cutter and motor
cables. The spiral wrap should extend as far
from the center panel as the tension idler
spring in the printer to prevent pinching the
cable.
6. Use the "Securing the Harness" procedure to
dress the wiring to clear moving parts and
provide service loops.
Spring
Spiral
Wrap
4. Remove the spiral wrap from the motor
(and cutter) cable. Do not pull the motor
cable's connector out of the motor.
Motor Connector
and Plug