Service manual

Cutter Cable
Preparations
The exterior cover must be removed prior to proceeding. (980428-101)
Note the main cable harness routing and cable tie positions. (980428-109)
64 980428-147 Rev. 1 Prelim.
Cutter
JP15
Removal
1. Cut the front tie-wrap securing the main
cable harness to the power supply. Caution
- Do not cut the cables!
2. Cut the tie-wrap securing the cutter cable to
the motor cable, if the cutter cable is already
installed.
3. Disconnect the cutter cable (JP15 from
main PCBA, if present.
Cut Tie-wraps