Service manual

Installation
1. Slide the printhead cable through the printhead carriage assembly.
2. Place the printhead carriage's pivot shaft into the pivot hole in the center panel.
2. Place the printhead side plate on the carriage printhead pivot hole on the opposite side.
Loosely secure the carriage and side plate to the extrusion bracket with three (3) screws and
washers.
3. Push the side plate to match the upper print mechanism's extrusion profile (rear and top).
Tighten the three (3) screws to 15.8 inch-pounds of torque.
4. Reposition the printhead spring to the carriage. Lift the printhead carriage up and push the
spring arm down and then into the carriage to engage.
5. Re-attach the printhead.
6. Verify the printhead's cable does not extend below the upper printhead extrusion.
980428-146 Rev. 1 Prelim. 63
Check that Cable routing does not extend
below this area with the print head
in the o
p
en or closed
p
ositions
Print Head
Cable