Service manual

5. Remove the lower print mechanisms extrusion bracket that the peel mechanism and label
rewind plate were mounted to.
6. Slide the latch assembly out of the assembly's shaft pivot in the center panel and the spring off
the post.
Installation
1. Loosely attach the extrusion to the center panel with a single screw in the bottom screw hole.
Let the extrusion swing down to the outside of the printer.
2. Slide a metal washer on each end, two (2) total, of the latch assembly's shaft. Insert the latch
assembly's shaft into the center panel.
2. Hook the spring to the post on the center panel and the latch assembly's prong.
3. Swing the extrusion up and attach it to the center panel with the other two screws to finish
mounting the extrusion. Be careful, do not knock the latch assembly out of the center panel.
Tighten the all three (3) screws to 11 inch-pounds torque.
4. Place the side plate on the latch assembly and attach the plate to the extrusion with three (3)
screws and washers. Tighten the three (3) screws to 11 inch-pounds torque.
5. Place, in sequence, the following on the outside platen shaft: a platen sleeve, flange bearing
(flange outside), and a nylon washer. Lock the them on the shaft with the E-ring.
6. Attach the (curved) label rewind plate with the two (2) flat head screws to the lower print
mechanism. Tighten the screws to 4.7 inch-pounds torque.
7. Attach the peel mechanism onto the lower print mechanism with two (2) flat head screws and
washers. Tighten the screws to 4.7 inch-pounds torque.
980428-144 Rev. 1 Prelim. 61
Post
Spring
Washers
Latch Assembly