Service manual

Lower Print Mechanism
Preparations
The exterior cover must be removed prior to proceeding. (980428-101)
The peel mechanism must be removed prior to proceeding. (980428-125)
Tools:
#1 & #2 Philips Screw drivers
11/32 Allen driver
Removal
1. Remove the peel mechanism from the lower print mechanism.
2. Remove the E-ring from the end of the platen shaft on the outside of the lower print
mechanism. Remove the nylon washer and flange bearing.
3. Remove the two (2) screws securing the (curved) label rewind plate from the lower mechanism.
4. Remove the three screws securing the side plate to the lower print mechanism. Slide the plate
off the platen shaft and latch assembly. Note the washer on the outside of the latch pivot shaft.
60 980428-144 Rev. 1 Prelim.