Service manual

Rewind Pulley, Tube & Shaft Support
Preparations
The exterior cover must be removed prior to proceeding. (980428-101)
The power supply must be loosened from the printer's bottom plate. (980428-103)
980428-140 Rev. 1 Prelim. 55
Tools:
#2 Philips screw driver
11/32 Allen driver
Removal
1. Partially disconnect the power supply and
place it next to the printer base to gain
access to the rewind assembly.
Ribbon
Pulley
(60 Tooth)
Ribbon
Drive Belt
(324 tooth)
Platen
Pulley
Clutch
Belt
Tension
Idler
Power Supply
Location
Rewind
Pulley
2. Loosen the ribbon belt by rotating the belt
tension idler counter-clockwise. Lift the
ribbon belt off the ribbon pulley.