Service manual

Peel Mechanism
Tools:
#1 Philips screw driver
Removal
1. Remove the two (2) screws holding the peeler mechanism to the lower print mechanism. The
peeler spacer plate will also become loose.
Installation
1. Place and hold the peeler spacer plate against the lower print mechanism with the cutout
facing down. Align the plate up with the mounting two (2) holes.
2. Place the peel mechanism against the spacer plate and insert the two (2) flat head screws.
Tighten the screws to 4.7 inch-pounds torque.
3. Optional - Verify the label rewind tube torque setting is set to 17 ±1 inch-pounds with the
“Tube Tension Adjustment Procedure”, 980428-154.
980428-125 Rev. 1 Prelim. 47