Service manual

42 980428-119 Rev. 1 Prelim.
4. Remove the four (4) screws holding the
control panel assembly to the front panel.
5. Pull the control panel assembly straight out
the front panel of the printer.
Installation
1. Insert the control panel cable into the
control panel's access hole. Pull the cable
through.
2. Re-attach the control panel assembly to the
inside of the front panel with the four (4)
retaining screws.
Tighten to 4.7±1inch-pounds of torque.
3. Plug the Control Panel’s cable into the main
PCBA at connector JP35.
3. Re-attach the control panel’s cable to the
main cable bundle at the front cable anchor
tie on the power supply. Use the "Securing
the Harness" procedure, 980428-009, to
complete dressing the control panel,
head-up and other cables.
Screws