Service manual

40 980428-118 Rev. 1 Prelim.
6. Finish sliding the two housings together.
Gently rock the lower housing while slowly
pushing the lower housing into the upper
housing.
4. Slide the sensor adjustment slide half way
into the lower housing.
5. Insert the cables into the slide access in the
upper housing.
7. Re-attach the lower housing to the upper
with the three (3) screws.
8. Install the label guide and sensor assembly
using the "Label Guide & Sensor"
procedure.
3. Add adhesive (hot melt glue or RTV) to the
end of the slide to secure the cables to the
slide. Remove excess adhesive immediately.
let the adhesive set before continuing.