Service manual

980428-118 Rev. 1 Prelim. 39
5. Remove the adhesive securing the cables at
the end of the slide. Caution - Do not
damage the slide or good cables or
good PCBAs.
6. Slide the appropriate cable out of the cable
clips. Note how the cables are attached and
routed.
7. While holding the slide to keep it from
spreading apart, gently pull the appropriate
PCBA from the slide.
Gap Receiver PCBA
Gap Emitter / Black Mark PCBA
Cable Clips
Cable Clips
Installation
1. Press the new PCBA onto the slide with the
components and cables facing up.
2. Route the cables flat against the slides
without twists and under the cable clips.
Cable Routed
Under Clips
4. Completely slide the lower and upper
housings from the slide.