Service manual

Label Sensor PCBAs
Preparations
The exterior cover must be removed prior to proceeding. (Procedure 980428-101)
Note the main cable harness routing and cable tie positions. (980428-109)
Remove the Label Sensor and Guide Assembly from the printer. (980428-117)
Tools:
#2 Philips screw driver
38 980428-118 Rev. 1 Prelim.
Removal
1. Slide the sensor adjustment slide into the
sensor housing.
2. Remove the three (3) screws attaching the
lower housing to the upper.
3. Gently rock the lower housing while slowly
pulling lower housing and slide parallel to
the upper housing.