Service manual

980428-117 Rev. 1 Prelim. 37
Installation
1. Slide the sensor guide's four (4) cables
through the sensor slide’s hole.
2. Insert and hook the label guide’s tab onto
the center panel’s cut-out.
3. Secure the label guide and sensor assembly
to the center panel with the pan head screw.
4. Close the printhead.
Hook guide to center panel
5. Re-connect the cables (JP27, JP28 and JP5)
to the Main PCBA. The five (5) conductor
cable exiting the bottom of the sensor slide
gets connected to JP5.
6. Re-tie the main PCBA harness. Use the
‘Securing the Wire Harness’ procedure,
980428-109, to properly re-attach the
cables.
3 conductor - JP27
2 conductor - JP28
(bottom set)
5 conductor - JP5
(bottom set)