Service manual

36 980428-117 Rev. 1 Prelim.
3. From the user’s access area (right side of
printer), open the printhead with the
printhead's release latch.
Adjust the sensor slide to the outside
position, away from the center panel of the
printer chassis.
4. Remove the pan head screw securing the
label guide and sensor assembly to center
panel of the printer chassis (user access
side).
Screw
Release Latch
5. Slide the label guide and sensor assembly
toward the front of the printer, (approx. 1/4"
parallel to the center panel) and pull the
assembly out away from the center panel
when it clears the panel.
Pull the sensor cables out through the center
panel.