Service manual

Label Guide & Sensor
Preparations
The exterior cover must be removed prior to proceeding. (980428-101)
Note the main cable harness routing and cable tie positions. (980428-109)
The Label Guide & Sensor assembly is mounted below the printhead assembly. The sensor slide
and cables pass through the center panel of the printer chassis and plug into the main PCBA.
Tools:
#2 Philips screw driver
980428-117 Rev. 1 Prelim. 35
Removal
1. Cut the two (2) tie-wraps securing the
sensor cable to the power supply.
Caution - Do not cut the cables!
2. Disconnect the label guide and sensor
cables (JP27, JP28 and JP5) from main
PCBA.
JP27
GAP-RX
JP28
GAP-TX
JP5
BLK-LNE
Cut Ties