Service manual

32 980428-115 Rev. 1 Prelim.
3. Disconnect the motor cable from the motor.
The motor connector can be pried off with a
large bladed screw driver. Pull the cable out
of the users side through the center panel’s
wall and out the service access side
4. Remove the spiral wrap from the old cable.
Installation
1. Add the spiral wrap to the new motor cable.
2. Pass the cable through the center panel’s
motor access hole and plug it into the
motor.
3. Slide the spiral wrapping until it is
positioned with two-third on the service side
of the center panel wall.
4. Re-attach the motor cable with the main
cable bundle to the front cable anchor tie on
the power supply. Use the "Securing the
Harness" procedure, 980428-009, to
complete dressing the motor and other
cables.