Service manual

Label Roll Support Assembly (Roll Holder)
Preparations
Before starting the procedure, open the printer, then remove any media from the printer.
The exterior cover must be removed prior to proceeding. (980428-101)
Tools:
#1 & #2 Philips screwdrivers
980428-111 Rev. 1 Prelim. 29
Removal & Replacement
1. Remove the four (4) screws securing the
Main PCBA to the chassis. Pull the main
PCBA off the stand-offs. Leave the cables
attached and gently lay the PCBA against
the printer and work surface.
2. Remove the four (4) mounting screws
securing the Label Roll Support assembly to
the center panel.
3. Install the new Label Roll Support assembly
with the four (4) screws and re-attach the
Main PCBA with it's screws.
Screws