Service manual

980428-109 Rev. 1 Prelim. 27
Rear
Anchor Tie
Rear Power Supply Cable Tie Point
1. Pull the control panel, label sensor and
head-up cables exiting the front cable
anchor tie to the rear cable anchor and tie
them loosely in place. Arrange the bundle
neatly. Pull the cable to the rear, taught
through the rear tie and tighten it tight.
Remove (cut) the excess tie.
2. Fold the excess cable from the sensors and
controls into the bundle. Tie the bundle with
a cable tie approximately one inch from
their connectors on the main board. Finish
tightening the tie wrap.
3. Verify there is approximately 1/8 inch
service loop on all the cables going from
the rear anchor tie to the connectors on the
main PCBA.
Final Check
1. Verify the printer cables and connectors are
not interfering (touching) with any moving
components (belts, gears or springs).
2. Verify all ties are snug.