Service manual

26 980428-109 Rev. 1 Prelim.
5. Pull the DC power cable through power
supply’s front cable anchor tie until no more
than 2 inches and no less than 1 inch of
service loop away from the front side of the
power supply.
Front
Anchor Tie
6. Position the motor cable’s spiral wrapping
to where one-third of the wrapping is
through the center panel towards the motor.
While holding the spiral wrapped portion
motor cable exiting the center panel parallel
to the printer base and roughly
perpendicular to the center panel, pull the
motor cable towards the main PCBA
through the power supply’s front cable
anchor tie.
7. Tighten the cable tie on the power supply’s
front cable anchor and remove (cut) the
excess off.