Service manual

Upper Case (Top Cover) Replacement - LP 2824 980358-314A
Preparations
Protect against static discharge. Your work area must be static-safe and include
a properly grounded conductive cushioned mat to hold the printer and a
conductive wrist strap for yourself.
Open the printer by pulling the release latches forward, then lifting the top cover. Remove media.
Removal
1. Unsnap the bracket ! .
2. Free the print head
" .
3. Slide the print head spring to one side to
release the opposite end.
4. Use a #1 Phillips driver to remove the
screws 1234 that hold the case to the
upper frame
#.
5. Lift the top case and window away.
Assembly
1. Align the window so that the holes fit onto
the pegs on the upper frame.
2. Align the case to hold the window in place.
4. Replace the four screws and use a #1
Phillips driver to tighten them.
5. Align the print head to plug the left and right connectors into the wire bundles.
6. Slide the print head into one side and jog it into the other side.
7. Align the pivots of the bracket onto the posts; then, snap the bracket into place.
8. Clean the print head with the cleaning pen.
Assembling the Printer
Reload media. Plug in the power cord, turn on the printer, load media, and run the AutoSense
routine to get a dump mode printout.
980358-001 Rev. A 57
MOVIE