Service manual

Latch Replacement - LP 2824 980358-311A
Preparations
Perform the removal steps of the Upper Case Replacement procedure (980358-314).
Open the printer by pulling the release latches forward, then lifting the top frame.
Removal
Lift both sides of the latch to 1 unsnap it from
the upper frame.
Assembly
1. Align the latch spring 2 so that is extends to
the rear of the latch.
2. Align the latch so that the spring faces the
rear of the printer.
3. Lower the latch into its notches
!" while
the spring provides tension against the
upper frame's front cross brace.
Assembling the Printer
Perform the assembly steps of the Upper Case
Replacement procedure (980358-314).
Reload media. Plug in the power cord, turn on
the printer, load media, and run the AutoSense
routine to get a dump mode printout.
56 980358-001 Rev. A
MOVIE