Service manual

Dispenser Bezel Replacement - 2824 980358-310A
Preparations
Protect against static discharge. Your work area must be static-safe and include
a properly grounded conductive cushioned mat to hold the printer and a
conductive wrist strap for yourself.
Perform the removal steps of the Bottom Case Replacement procedure (980358-305).
Removal
1. Pry either side free and then lift the bezel 1
away from the dispenser bar 2 and bottom
frame assembly.
2. Note the location of the connector
! on
the main control board; then unplug it.
3. Pull the wires and connector through the
frame access
".
Assembly
1. Align the bezel so that the connector is to
the rear.
2. Thread the connector and wires through the
access in the bottom case
" and the
protective separator ("fish paper")
#.
3. Plug the connector into its location on the
main control board.
4. Align the tabs with the notches in the media
exit and snap the bezel into place.
Assembling the Printer
Perform the assembly steps of the Bottom Case
Replacement procedure (980358-305). Check
the installation. Turn on the printer and run the
AutoSense routine to get a dump mode
printout. This action test the printer's media
drive and printing capabilities.
980358-001 Rev. A 55
MOVIE