Service manual

Hinge Replacement - TLP 2844 980358-413A
Preparation
Perform the removal steps of the Bottom Case
(980358-405) and Main PCBA (980358-409)
and Cover Support (980358-412) procedures.
Removal
1. Use a #1 Phillips driver to loosen and
remove the screw 1 that holds the hinge
lock 2 onto the bottom media frame
!.
2. Slide the hinge off of the frame.
3. Slide the top cover assembly
" and
bottom media frame apart.
Installation
1. Ensure the wires follow their correct routing.
On the side opposite the hinge, make sure
the cables go through the channel
'.
2. Slide the top cover assembly and bottom
media frame together.
4. Align the hinge with the link tab
# facing
right and insert into the top cover assembly.
Note: Make certain that the link tab
engages with the link
$ inside the top
case.
5. Fit the hinge onto the bottom media frame.
6. Replace the screw and use a #1 Phillips
driver to tighten it.
7. Ensure the hinge caps
%& are inserted
properly.
Assembling the Printer
Perform the assembly steps of the Cover
Support (980358-412), Main PCBA
(980358-409) and Bottom Case (980358-405)
procedures.
980358-001 Rev. A 35
MOVIE