Service manual

Cover Support Replacement - TLP 2844 980358-412A
Preparations
Open the printer by pulling the release latches forward, then lifting the top cover.
Removal
1. Use a #1 Phillips driver to remove the two
screws 23holding the support 1 to the
top assembly
!.
2. Lift the support away from the bottom
assembly
".
Assembly
1. Align the support so that the square brace
fits into the top assembly.
2. Insert the support into the bottom assembly.
3. Replace the two screws that hold the
support the top assembly and use a #1
Phillips driver to tighten them.
34 980358-001 Rev. A
MOVIE