User Manual
Table Of Contents
- Declaration of Conformity
- Contents
- About This Document
- Introduction
- Printer Setup
- Operations
- Configuration
- Routine Maintenance
- Troubleshooting
- Specifications
- End User License Agreement
- Glossary
- Index
55
Operations
Load Media in Cutter Mode
3/12/09 Xi4 User Guide P1009874-001
3. Open the printhead assembly by rotating the printhead-open lever (1) counter-clockwise.
4. Loosen the thumb screw (not visible from this angle) that is located on the bottom of the
outer media guide (
1).
5. Slide the outer media guide (1) all the way out.
1
1
1