Specifications

4 - 24 FX Series RFID Readers Integrator Guide
SNMP Settings
Select SNMP to view the Configure SNMP Settings window. Use this window to configure the SNMP host settings to
allow sending Network Status Events and receiving Network Status Event notifications:
Send SNMP Trap To - Configures the host IP address to which the SNMP trap is sent. Leave this blank to send
no traps to any host.
SNMP Community String - SNMP community string to use for SNMP set and get.
SNMP Version - SNMP version to use in the reader. Supported versions are V1 and V2c.
Send Server Heartbeat - Sends a heartbeat message periodically to the configured SNMP host.
Figure 4-23
Configure SNMP Settings Window
NOTE Send SNMP Trap To and Send Server Heartbeat take effect immediately after clicking Set Properties.
However, perform a Commit to persist the changes. The modified SNMP Community String and SNMP
Version are not affected until the reader reboots.