User guide

Configuration
Control Panel LCD Displays
84
57516L-002 Rev. A 170PAX4 User Guide 1/10/06
Reset Network
2,3
This option resets the wireless card and the print server when the wireless
option is running. Selecting this option has no effect when the wireless
option is not running, when there is no card inserted, or when the wireless
password is anything other than the default (zero).
1. Press the right oval to select
YES.
The LCD prompts
ARE YOU SURE?.
• Press the left oval to select
NO and cancel the request.
• Press the right oval to select YES and reset the network.
Table 8 • Print Server Parameters (Page 4 of 4)
Parameter Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the print engine obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the print engine password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
RESET NETWORK
YES