User guide

83
Configuration
Control Panel LCD Displays
1/10/06 170PAX4 User Guide 57516L-002 Rev. A
Enable LEAP Mode
3,4
LEAP is an encryption method that is available with some wireless cards.
Set the LEAP user name and password through the print engine web pages.
Default: OFF
Selections: ON, OFF
To change the value shown:
1. Press the left or right oval to toggle between the options.
Select Encryption Mode
1,3
Select whether to use 40-bit encryption, 128-bit encryption, or no
encryption.
Important • If using encryption, use the ^WE ZPL command to set
the value for the active encryption key. Failure to do so can disable
the wireless system. For more information, see the Wireless Print
Server User Guide.
Default: OFF
Selections: OFF, 40-BIT, 128-BIT
To change the value shown:
1. Press the left or right oval to scroll through the options.
Select Encryption Index
1,3
Use this parameter to tell the print engine which encryption key to use.
Important • Use the ^WE ZPL command to set the value for the
active encryption key. Failure to do so can disable the wireless
system. For more information, see the Wireless Print Server User
Guide.
Default: 1
Selections: 1, 2, 3, 4
To change the value shown:
1. Press the left or right oval to scroll through the options.
Table 8 • Print Server Parameters (Page 3 of 4)
Parameter Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the print engine obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the print engine password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
LEAP MODE
OFF
ENCRYPTION MODE
OFF
ENCRYPT. INDEX
1