User guide

Configuration

Control Panel LCD Displays

1/10/06 170PAX4 User Guide 57516L-002 Rev. A

Print Server LCD Displays

The menu options shown in Table 8 display only if you have a print server installed.

Table 8 • Print Server Parameters (Page 1 of 4)

Parameter Action/Explanation

Load LAN Source

This parameter, which serves the same function as the ^NP ZPL command,

specifies whether to use the print engine’s or the print server’s IP settings at

bootup.

Default: PRINTER

Selections: PRINTER, PRINTSERVER

To change the value shown:

1. Press the left or right oval to toggle between the options.

Check for Wired PrintServer

This parameter, which serves the same function as the ^NB ZPL command,

tells the print engine whether to search for a wired print server at bootup.

Default: NO

Selections: YES, NO

To change the value shown:

1. Press the left or right oval to toggle between the options.

Specify IP Protocol

Allows either the user (permanent) or the server (dynamic) to select the

IP address. If a dynamic option is chosen, this selection determines the

method(s) by which the print server (wired or wireless) receives the IP

address from the server.

Default: ALL

Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP,

DHCP AND BOOTP, PERMANENT

Note • Use of GLEANING ONLY is not recommended when the

Wireless Print Server is installed.

To change the value shown:

1. Press the left or right oval to scroll through the options.

1 Appears only when the ZebraNet Wireless Print Server is installed.

2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the

print server is recognized, all zeroes (000.000.000.000) will display until the print engine obtains an IP address or defaults to

address 192.168.254.254.

3 If a wireless password is set, you must enter the wireless password (not the print engine password) to access this parameter.

4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the

card supports LEAP.

LOAD LAN FROM?

PRINTER

WIRED PS CHECK?

IP PROTOCOL

ALL