User guide

Configuration
Control Panel LCD Displays
76
57516L-002 Rev. A 170PAX4 User Guide 1/10/06
Set Applicator Port Mode
Determines the action of the applicator port.
Note • Set this value as suggested by the applicator manufacturer.
Default: OFF
Selections: OFF, MODE 1, MODE 2, MODE 3, MODE 4
• OFF: The applicator port is off.
• MODE 1: Asserts the ~END_PRINT signal low while the
print engine is moving the label forward.
• MODE 2: Asserts the ~END_PRINT signal high while the
print engine is moving the label forward.
• MODE 3: Asserts the ~END_PRINT signal low for 20 milliseconds
when a label has been completed and positioned. Not asserted during
continuous printing modes.
• MODE 4: Asserts the ~END_PRINT signal high for 20 milliseconds
when a label has been completed and positioned. Not asserted during
continuous printing modes.
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Applicator Error Signal When Print Engine Pauses
When this option is enabled and the print engine is paused, the print engine
sets the applicator error state.
Default: ENABLED
Selections: ENABLED, DISABLED
To change the value shown:
1. Press the left or right oval to toggle between the options.
Table 6 • Print Engine Parameters (Page 22 of 26)
Parameter
Action/Explanation
APPLICATOR PORT
- OFF +
ERROR ON PAUSE
- ENABLED +