User guide

Configuration
Control Panel LCD Displays
66
57516L-002 Rev. A 170PAX4 User Guide 1/10/06
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1. Press the right oval to select YES.
If your print engine is set to require a password, you are prompted to
enter the password.
2. Enter the password. For instructions, see Change Password-Protected
Parameters on page 52.
The display shows
INITIALIZE FLASH?
3. Press the right oval to select YES.
The display shows
ARE YOU SURE?.
4. Do you wish to continue?
• Press the left oval to select
NO to cancel the request and return to the
INITIALIZE FLASH prompt.
• Press the right oval to select
YES and begin initialization.
When initialization is complete, the print engine automatically exits
Setup mode, and the control panel displays
PRINTER READY. If
you exit Setup mode while initialization is still in process, the control
panel display flashes between the phrases
CHECKING E: MEMORY
and
PRINTER IDLE.
Note • Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
Table 6 • Print Engine Parameters (Page 12 of 26)
Parameter
Action/Explanation
INIT FLASH MEM.
YES