User guide

59
Configuration
Control Panel LCD Displays
1/10/06 170PAX4 User Guide 57516L-002 Rev. A
Set Maximum Label Length
This parameter is used during the media portion of the calibration process.
Always set maximum label length to a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length (Figure 30). If the value is set
to a smaller value than the label length, the print engine assumes that
continuous media is loaded, and the print engine cannot calibrate.
For example, if the label length is 5.0 inches (126 mm) including the
interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length
is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).
Figure 30 • Label Length
Default: 39.0 inches (988 mm).
Range: Values are adjustable in one-inch (25.4 mm) increments.
To change the value shown:
1. Press the right oval to increase the value.
2. Press the left oval to decrease the value.
Table 6 • Print Engine Parameters (Page 5 of 26)
Parameter
Action/Explanation
MAXIMUM LENGTH
-39.0 IN 988 MM
}
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set maximum label length to approximately
this value
1
3