User guide

57
Configuration
Control Panel LCD Displays
1/10/06 170PAX4 User Guide 57516L-002 Rev. A
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing.
See Figure 29. Higher numbers move the media out (the tear line moves
closer to the leading edge of the next label), and lower numbers move the
media in (the tear line moves closer to the edge of the label just printed).
Figure 29 • Tear-Off Position Adjustment
Default: +0
Range: –120 to +120
To change the value shown:
1. Press the right oval to increase the value. Each press adjusts the tear-off
position by four dot rows.
2. Press the left oval to decrease the value. Each press adjusts the tear-off
position by four dot rows.
Select Print Mode
Print mode settings tell the print engine the method of media delivery that
you wish to use. Make sure that your print engine can support the selected
option.
Default: APPLICATOR
Selections: TEAR-OFF, REWIND, APPLICATOR
To change the value shown:
1. Press the left or right oval to scroll through the options.
Table 6 • Print Engine Parameters (Page 3 of 26)
Parameter
Action/Explanation
TEAR OFF +000
- +
1
Media direction
2
Factory-set tear line location at position 00
1
2
PRINT MODE
-APPLICATOR +