User guide

43
Operations
Load Ribbon
1/10/06 170PAX4 User Guide 57516L-002 Rev. A
6. Place an empty ribbon core (1) onto the ribbon take-up spindle (2), and then push the core
toward the print engine frame until it is fully seated.
7. Attach the end of the ribbon to the empty ribbon core with adhesive tape or a label, and
wind for several turns in the direction shown. Wind the ribbon evenly on the spindle.
8. Close the printhead assembly by rotating the printhead latch (1) until it latches onto the
locking pin (
2).
9. Close the media door.
Left-Hand Right-Hand
Left-Hand Right-Hand
1
2
1
2
1
2