User guide

35
Operations
Load Media
1/10/06 170PAX4 User Guide 57516L-002 Rev. A
5.
6.
See Figure 22. Thread the media through the upper media path as follows:
a. Under the upper guide post (
1)
b. Between the top media sensor track assembly (
2) and the label guide shelf
assembly (
3)
c. Below the pinch roller assembly (
4)
d. Under the printhead assembly (
5)
7. See Figure 22. Extend approximately 30 in. (75 cm) of media past the peel bar (6).
Remove and discard the labels from the liner (
7).
Figure 22 • Threading the Media
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Open the printhead assembly by unlatching the printhead latch (1) from the
locking pin (
2).
1
2
1 4
5
7
2 3
6