User guide

Print Engine Setup

Connect the Print Engine to a Power Source

1/10/06 170PAX4 User Guide 57516L-002 Rev. A

Connect the Print Engine to a Power Source

The power supply in the print engine automatically detects the applied line voltage and works

in the 90 to 264 VAC, 47 to 63 Hz range.

The AC power cord must have a three-prong female connector on one end that plugs into the

mating AC power connector at the rear of the print engine. If a power cable was not included

with your print engine, refer to Power Cord Specifications on page 22.

To connect the print engine to a power source, complete these steps:

1. Turn the print engine power switch to the Off (O) position.

2. Refer to Figure 10. Plug the power cord into the AC power connector on the rear of the

print engine.

3. Plug the other end of the power cord into a power outlet near the print engine.

Figure 10 • Power Connection

Caution • For personnel and equipment safety, always use an approved three-conductor

power cord specific to the region or country intended for installation. This cord must use an

IEC 320 female connector and the appropriate region-specific three-conductor grounded

plug configuration.

Left-Hand Right-Hand

AC power connector