User guide

19
Print Engine Setup
Print Engine Installation
1/10/06 170PAX4 User Guide 57516L-002 Rev. A
Figure 8 • Rear View of Right-Hand Print Engine
Install the Print Engine in an Applicator
This section provides the basic instructions for installing the print engine into an applicator.
To install the print engine into an applicator, complete these steps:
1. See Figure 9. Install the center mounting bolt into the center hole on the applicator.
2. Carefully place the keyhole on the center mounting bolt.
3. Install the four corner mounting screws to secure the print engine to the applicator.
9.646 in.
(245 mm)
9.252 in.
(235 mm)
4.626 in.
(117.5 mm)
0.197 in.
(5 mm)
0.451 in.
(
11.45 mm)
8.748 in.
(222.2 mm)
0.197 i
n.
(5 mm
)
10.433 in.
(265 mm)
11.811
in.
(300 m
m)
Caution • If the print engine is installed improperly, it could fall out of the applicator and
cause injury. The center mounting bolt and four mounting screws must be installed and
secured. See Figure 9 for the location of the bolt and screws.
Note • The keyhole and the center mounting bolt are designed to support the print engine
and assist in installing and removing the four mounting screws.