User guide

151
Index
1/10/06 170PAX4 User Guide 57516L-002 Rev. A
printer settings
applicator port, 76
backfeed, 74
baud, 69
calibration methods, 45
control prefix, 71
data bits, 69
date, 80
delimiter character, 72
format convert, 79
format prefix, 72
head resistor, 75
host handshake, 70
idle display, 80
IP settings, 81
label top, 74
language, 80
LCD, 79
left position, 75
maximum label length, 59
media type, 58
network configuration label as baseline, 54
network ID, 70
parallel communications, 69
parity, 70
print darkness, 55
print method, 58
print server settings, 81
print width, 58
protocol, 70
resynch mode, 77
saving, 51
serial communications, 69
setting through control panel, 50
start print signal, 77
time, 80
ZPL mode, 72
printhead
cleaning, 89
head close setting, 74
head resistor value setting, 75
pressure adjustment, 92
when to clean, 86
printing specifications, 141
product markings, 138
protocol setting, 70
R
recycling the printer, 15
reflective media sensor, 47
remove used ribbon, 44
report shipping damage, 15
reprint mode, 78
requirements for installation, 16
reset network option, 84
restore
factory default settings, 51
network settings, 51
resynch mode setting, 77
Rewind mode
selecting, 57
ribbon
adhesive test, 30
determining coated side, 29
loading, 39
low ribbon output, 78
low ribbon warning, 78
ordering, 3
removal, 44
ribbon LED setting, 79
RIBBON light, 11
scratch test, 30
specifications, 140
when to use, 29
RIBBON IN message, 98
RIBBON OUT message, 97
Ribbon S. setting, 79
ribbon sensor
adjusting, 47
calibration procedure, 68
sensitivity calibration, 46
when to clean, 86
roll media
described, 27
RS-232 serial interface, 24
connections, 124
RTC (Real-time clock) setting
date, 80
idle display, 80
time, 80