User guide

1/10/06 170PAX4 User Guide 57516L-002 Rev. A
Index
A
adhesive test for ribbon coating, 30
adjustments
LCD, 79
left position, 75
media sensors, 47
print darkness, 55
printhead pressure, 92
tear-off position, 57
toggle positioning, 91
agency approvals, 138
applicator
+24-28V isolated and non-isolated modes, 132
+5V isolated and non-isolated modes, 131
applicator interface connector, 126
interface pin configuration, 127
signals during applicator modes, 126
applicator interface, 25
applicator port setting, 76
authentication type, 82
auto-calibration, 45
B
backfeed setting, 74
bar codes
list available codes, 63
specifications, 142
baud setting, 69
before you begin setup, 14
bitmap scaling factor, 79
black mark media
described, 27
buttons on control panel, 9
C
cable requirements, 26
calibration
CALIBRATE button description, 10
media and ribbon sensor, 68
methods, 45
setting for head close, 74
setting for media power up, 73
CANCEL button
CANCEL self test, 109
description, 9
checklist
before you begin, 14
troubleshooting, 96
cleaning
exterior of print engine, 86
media compartment, 87
printhead and platen roller, 89
recommended schedule, 86
communication interfaces
overview and location, 23
types of connections, 24
communications diagnostics test
overview, 117
selecting, 71
communications problems, 105
Compact Flash card initialization, 65
configuration
changing parameters, 55
enter Setup mode, 50
exit Setup mode, 51
configuration label
printing using CANCEL self test, 109
printing using List Setup command, 64