User guide

78 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1

Print Engine Configuration

Front Panel LCD

Select Encryption Mode

1,3

• Press the right or left oval to display other choices.

Default: OFF

Selections: OFF, 40-BIT, 128-BIT

Select Encryption Index

1,3

• Press the right or left oval to display other choices.

Default: 1

Selections: 1, 2, 3, 4

Reset Network

2,3

This option resets the wireless card and the print server when the wireless

option is running. Selecting this option has no effect when the wireless

option is not running, when there is no card inserted, or when the wireless

password is anything other than the default (zero).

1. Press the right oval to select YES.

The LCD prompts

ARE YOU SURE?.

• Press the left oval to select

NO to cancel the request.

• Press the right oval to select YES and reset the network.

Table 7 • Print Server LCD Displays (Continued)

Parameter Action/Explanation

1 Appears only when the ZebraNet Wireless Print Server is installed.

2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the

print server is recognized, all zeroes (000.000.000.000) will display until the print engine obtains an IP address or defaults

to address 192.168.254.254.

3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.

4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the

card supports LEAP.

ENCRYPTION MODE

OFF

ENCRYPT. INDEX

RESET NETWORK

YES