User guide

Print Engine Configuration
Front Panel LCD
57516L-001 Rev. 1 10/12/2004 170PAX4 User Guide 77
IP Address
2
This parameter allows you to select the IP address if PERMANENT was
chosen in IP PROTOCOL. (If a dynamic option was chosen, the user
cannot select the address.)
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
Subnet Mask
2
This parameter selects the part of the IP address that is considered to be
part of the local network. It can be reached without going through the
default gateway.
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
Default Gateway
2
This parameter allows you to select the IP address that the network traffic
is routed through if the destination address is not part of the local network.
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
View MAC Address
1,3
This parameter cannot be changed through the front panel.
View ESSID
1,3
This parameter cannot be changed through the front panel.
Select Authentication Type
1,3
• Press the right or left oval to display other choices.
Default: OPEN
Selections: OPEN, SHARED
Enable LEAP Mode
3,4
LEAP is an encryption method that is available with some wireless cards.
Set the LEAP user name and password through the printer web pages.
• Press the right or left oval to display other choices.
Default: OFF
Selections: ON, OFF
Table 7 • Print Server LCD Displays (Continued)
Parameter Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the print engine obtains an IP address or defaults
to address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
IP ADDRESS
000.000.000.000
SUBNET MASK
000.000.000.000
DEFAULT GATEWAY
000.000.000.000
MAC ADDRESS
000000000000
ESSID
125
AUTH. TYPE
OPEN
LEAP MODE
OFF